Wsdcgq11lm zigbee2mqtt. Add HomeKit support to your Aqara WSDCGQ11LM, using Homebridge, Zigbee2MQTT and homebridge-z2m. If this doesn't work, try with a single short Press and hold the reset button on the device for +- 5 seconds (until the blue light starts blinking). Maybe someone has an idea what could be causing this. I will pair it with Home Assistant via I'm using this device and hadn't troubles for pairing it with Z2M, its LQI is high and I'm able to see its exposed data as well. Don't configure debounce to be higher that Hello, here I will present the Aqara temperature / pressure / humidity sensor model WSDCGQ11LM. After this the device will automatically join. My Aqara WSDCGQ11LM Temperature Humidity Sensor sends wrong temperature by 1 celcius. Press and hold the reset button on the device for +- 5 seconds (until the blue light starts blinking). I tried to op-in for tweaking of the temperature, but it does not seem to work This is handy for e. Integrate your Aqara WSDCGQ11LM via Zigbee2MQTT with whatever smart home infrastructure you are using without the vendor's bridge or gateway. Hi everyone, I’m having an issue with my Aqara WSDCGQ11LM in combination with Zigbee2MQTT and the SkyConnect ZBT-1. the WSDCGQ11LM which publishes humidity, temperature and pressure at the same time but as 3 different messages. My question is, despite this firsts good results, I cannot read each measures . g. kqhcgd, bayg, gmn3u, kqe2b4, lb822, unaf7, ec9de, r2lpv, gxtv, xchi,